Volume 17, Issue 11 (1-2018)
Modares Mechanical Engineering 2018, 17(11): 311-322 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Sadegh yazdi M, Bakhshi M, Gorji H, Shakeri M, Khademi M. Optimization of pressure paths in hydrodynamic deep drawing assisted by radial pressure with inward flowing liquid using a hybrid method. Modares Mechanical Engineering 2018; 17 (11) :311-322
URL: http://mme.modares.ac.ir/article-15-11499-en.html
URL: http://mme.modares.ac.ir/article-15-11499-en.html
1- PhD student,Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
2- Professor,Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
3- Associate Professor, Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
4- Professor Fuel Cell Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
5- MSc graduate,Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
2- Professor,Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
3- Associate Professor, Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
4- Professor Fuel Cell Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
5- MSc graduate,Metal Forming Research Center, Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
Abstract: (3799 Views)
Hydroforming is a convenient method for applying fluid to produce parts with high strength to weight ratio. Hydrodynamic deep drawing assisted by radial pressure with inward flowing liquid process is considered as a type of hydroforming. In this method, radial and cavity pressures are two most important parameters, the values of which at any moment play an important role on the quality of final part. In this study, based on a hybrid method, the cavity and radial pressure paths in hydrodynamic deep drawing assisted by radial pressure with inward flowing liquid process are optimized. In this method, an adaptive simulation that is integrated with the fuzzy control system with the ABC algorithm is used to determine the optimized radial and cavity pressure paths. The achievement of a cup with least thinning and without wrinkling has been defined as the optimization goal. The validity of radial and cavity pressure paths obtained from optimization algorithm is verified through an experiment. Results showed that utilization of the optimized loading path yields the part with lower maximum thinning and without wrinkling.
Article Type: Research Article |
Subject:
Metal Forming
Received: 2017/09/5 | Accepted: 2017/10/31 | Published: 2017/11/18
Received: 2017/09/5 | Accepted: 2017/10/31 | Published: 2017/11/18
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |