Volume 15, Issue 3 (2015)                   Modares Mechanical Engineering 2015, 15(3): 63-74 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Taghipour Birgani P, Naderan Tahan K, Sodagar S, Shishesaz M. Suitable parameters determination of lamb wave generation source with low-attenuation for three-layer adhesive joints inspection. Modares Mechanical Engineering. 2015; 15 (3) :63-74
URL: http://journals.modares.ac.ir/article-15-1593-en.html
1- ‍Ph.D. Student/Shahid Chamran University
2-
3- Assistant Professor-Department of Technical Inspection Engineering, Abadan Institute of Technology, Petroleum University of Technology, Ahvaz, Iran
4- Professor-Department of Mechanical Engineering, Shahid Chamran University, Ahvaz, Iran
Abstract:   (2449 Views)
In this paper, Propagated modes in a three-layer adhesive joint are investigated regardless of wave generation source influence and also by taking into consideration it and low-attenuation modes are determined. In the beginning, lamb wave propagation in the adhesive joints is investigated using global matrix method and characteristic equation is derived by applying continuity and boundary conditions which are included traction-free boundary conditions on outer surfaces of the joints and continuity between layers. Phased velocity and attenuation dispersion curves in terms of frequency are obtained by numerical solution of the characteristic equation. Then, the source influence on wave field is investigated using normal mode expansion method. Average power flow of low-attenuation excited mode and its energy percent to the lamb wave total energy curves in terms of source parameters for specific frequency are obtained. These results are used to determine the suitable parameters of the source which are used to generate low-attenuation lamb wave mode. Finally, finite element simulation of lamb wave generation is performed to compare with the results of normal modes expansion method. The results indicate to generate M3 mode with low-attenuation level in the three-layer adhesive joint aluminium-epoxy-aluminium at frequency 0.25 MHz, suitable wedge angle is 16 degree and suitable transducer width is 20 mm.
Full-Text [PDF 596 kb]   (2469 Downloads)    
Article Type: Research Article | Subject: Non Destvuctive Test
Received: 2014/11/11 | Accepted: 2014/12/6 | Published: 2015/01/24

Add your comments about this article : Your username or Email:
CAPTCHA