Volume 6, Issue 1 (2014)                   Modares Mechanical Engineering 2014, 6(1): 87-102 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Ghoreishi M, Assarzadeh S. Prediction of Material Removal Rate and Surface Roughness in Electro-Discharge Machining (EDM) Process Based on Neural Network Models. Modares Mechanical Engineering. 2014; 6 (1) :87-102
URL: http://journals.modares.ac.ir/article-15-3040-en.html
1- Department, K.N. Toosi University of Technology
Abstract:   (4007 Views)
The complex and stochastic nature of the electro-discharge machining (EDM) process has frustrated numerous attempts of physical modeling. In this paper two supervised neural networks, namely back propagation (BP), and radial basis function (RBF) have been used for modeling the process. The networks have three inputs of current (I), voltage (V) and period of pulses (T) as the independent process variables, and two outputs of material removal rate (MRR) and surface roughness (Ra) as performance characteristics. Experimental data, employed for training the networks and capabilities of the models in predicting the machining behavior have been verified. For comparison, quadratic regression model is also applied to estimate the outputs. The outputs obtained from neural and regression models are compared with experimental results, and the amounts of relative errors have been calculated. Based on these verification errors, it is shown that the radial basis function of neural network is superior in this particular case, and has the average errors of 8.11% and 5.73% in predicting MRR and Ra, respectively. Further analysis of machining process under different input conditions has been investigated and comparison results of modeling with theoretical considerations shows a good agreement, which also proves the feasibility and effectiveness of the adopted approach.
Full-Text [PDF 215 kb]   (5898 Downloads)    

Received: 2002/04/21 | Accepted: 2004/08/10 | Published: 2006/05/5

Add your comments about this article : Your username or Email:
CAPTCHA