Volume 12, Issue 2 (6-2012)                   Modares Mechanical Engineering 2012, 12(2): 125-133 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

khosravi S, ansari M. The effect of various parameters on breakup length of the outflow from the nozzle. Modares Mechanical Engineering 2012; 12 (2) :125-133
URL: http://mme.modares.ac.ir/article-15-6189-en.html
1- Tarbiat Modares University
2- -
Abstract:   (6243 Views)
Abstract: in this article, jet flow from the nozzle exit was considered and calculated numerically in transient two-phase flow and two-dimensional axsymmetric turbulent condition using volume of fluid method (VOF). The hydrodynamical instability for jet flow was analyzed and the breakup length was calculated, the nozzle diameter of 0.11875mm, 0.2375mm and 0.475 mm, the center line velocity of the fluid in the 15.416 m/s and 7.708 m/s and the fluid inside the nozzle used for the calculation are water and gas oil. Fluent 6.3.26 was used for two-phase flow analysis. The results obtained from the present numerical simulation compared with the experimental results of the previous researches, good agreement was obtained. It was concluded that the breakup length decreases as the relative velocity between the phases increase or the liquid density decreases. The nozzle diameter is an important parameter which effect of the nozzle outlet regime and the breakup length.
Full-Text [PDF 5375 kb]   (5390 Downloads)    
Article Type: Research Article | Subject: robatic
Received: 2011/09/12 | Accepted: 2012/01/16 | Published: 2012/06/21

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.