Volume 15, Issue 3 (2015)                   Modares Mechanical Engineering 2015, 15(3): 106-112 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Shabgard M R, Karamzadeh B, Alizadegan R, Gholipoor A. Experimental study of finishing of AISI H13 hot work steel using Abrasive Flow Finishing (AFF) process. Modares Mechanical Engineering. 2015; 15 (3) :106-112
URL: http://journals.modares.ac.ir/article-15-6420-en.html
Abstract:   (2565 Views)
In this research the abrasive flow finishing process (AFF) of AISI H13 hot work steel was studied and the effects of various process parameters such as flow pressure (extrusion pressure), abrasive particles densities, abrasive particles sizes and the first quality of surfaces on variations of surface roughness and material removal have been investigated. The results showed that increasing the density of abrasive particles leads to increase in variations of surface roughness and material removal. Increase of extrusion pressure from 4 to 6 MPa causes the increase in variations of surface roughness and material removal and from 6 to 8 Mpa leads to decrease in the two latter. Electron microscopic results showed that increase of finishing process time over 4 hours causes a detrimental effect on the surface of the specimens, as a result of penetration and stabilization of abrasive particles in the form of broken particles. Also according the results of this paper, increasing the size of abrasive particles leads to higher variations of surface roughness and material removal, and this process is more effective in finishing of rougher surfaces.
Full-Text [PDF 615 kb]   (2233 Downloads)    
Article Type: Research Article | Subject: Production Methods
Received: 2014/12/10 | Accepted: 2015/01/5 | Published: 2015/01/24

Add your comments about this article : Your username or Email:
CAPTCHA