Volume 11, Issue 3 (2011)                   Modares Mechanical Engineering 2011, 11(3): 1-12 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

jahanpour J. Jerk limited machining using C2 Pythagorean-hodograph (PH) quintic spline curves. Modares Mechanical Engineering. 2011; 11 (3) :1-12
URL: http://journals.modares.ac.ir/article-15-8349-en.html
1- Islamic Azad University, Mashhad Branch
Abstract:   (3255 Views)
In this paper, Pythagorean-hodograph (PH) quintic spline curves constructed by several connected PH curves with C2 continuity are used to designing the toolpath in machining operation. To generate the toolpath commands, the acceleration/ deceleration phase of motion and the middle regions of the toolpath are devised by time-dependent and constant velocity interpolation algorithms, respectively. In the aforementioned interpolation algorithm, the exponential functions are employed to modify the feedrate profile and subsequently using the Pattern Search algorithm (PSA), the proposed feedrate profile is optimized to maintain the maximum jerk within allowable physical limits. Finally, high speed CNC machining for two cases of open and closed C2 PH quintic spline curves along with the commonly used feed forward/feedback controller is simulated in Simulink-Matlab software and the contouring error is studied and analyzed.
Full-Text [PDF 1274 kb]   (2125 Downloads)    

Received: 2011/03/6 | Accepted: 2011/09/30 | Published: 2011/10/1

Add your comments about this article : Your username or Email:
CAPTCHA