Volume 17, Issue 1 (2017)                   Modares Mechanical Engineering 2017, 17(1): 95-105 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Sarmast S, Shamekhi A, Zia Basharhagh M, Parivar A. The Effect of Injector Angle and Start of Injection on Spray-Wall Interaction in Gasoline Direct Injection Engine. Modares Mechanical Engineering. 2017; 17 (1) :95-105
URL: http://journals.modares.ac.ir/article-15-8938-en.html
Abstract:   (1888 Views)
Fuel consumption, emissions and output power are some of the very important factors for automotive engine design. Since the combustion efficiency depends on the quality of the air-fuel mixture and mixture quality depends on the fuel injection parameters, the investigation of spray features is an overall goal in direct injection engines. In this paper, simulation of GDI spray is carried out in a constant volume chamber contains nitrogen in four different injection pressure using the AVL Fire software. The results are validated against the Istituto Motori-CNR experimental data. The log-normal probability distribution as an initial droplet diameter and Huh-Gosman model as secondary breakup were used. Then the combustion of EF7 Engine with direct injection was studied and wall film thickness was compared at different injection pressures and injector angles. Also, the effects of wall temperature and single-stage and two-stage fuel injection with different ratios of injected fuel mass were evaluated on the wall film. Since the fuel can be injected into the combustion chamber in both intake and compression stroke according to engine operating conditions in gasoline direct injection engines, the simulation was done for open cycle engine.
Full-Text [PDF 1734 kb]   (2204 Downloads)    
Article Type: Research Article | Subject: Internal Combustion Engine
Received: 2016/11/7 | Accepted: 2016/12/15 | Published: 2017/01/4

Add your comments about this article : Your username or Email: