Volume 16, Issue 6 (8-2016)                   Modares Mechanical Engineering 2016, 16(6): 108-118 | Back to browse issues page

XML Persian Abstract Print


Abstract:   (5258 Views)
Harvesting energy by piezoelectric materials is nowadays an efficient way for powering low-power electric devices. Required energy for sensors which are used in condition and health monitoring of bridges and other civil infrastructures can be examples of the energy harvesters. This study aimed to improve the piezoelectric-based energy harvesting on civil infrastructures, especially on bridge structures. In this investigation, harvesting energy from the vibrations of a bridge under moving consecutivemasses is studied. Harvesting energy iscarried out through a cantilever beam with piezoelectric patch which is installed atthe middle of a simply supported bridge. Governing equations for vibration of an Euler-Bernoulli beam under moving consecutivemasses arederived. The effects of inertial, centrifugal and coriolis forces areconsidered. For verifying, the results of the numerical solution of the moving mass problem are compared to the experimental tests data of the litterature. The harvester is modelled by a cantilever beam with piezoelectric patch under base excitations which are calculated from vibrations of the bridge mid-point. The obtained equations are then solved in MATLAB environment by using the forth order Runge-Kutta method. The calculated induced voltages are compared with those obtained from experiment. A good degree of accuracy is observed.
Full-Text [PDF 723 kb]   (6032 Downloads)    
Article Type: Research Article | Subject: Vibration
Received: 2016/04/17 | Accepted: 2016/05/13 | Published: 2016/06/14

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.