Volume 13, Issue 6 (9-2013)                   Modares Mechanical Engineering 2013, 13(6): 103-113 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Zakeri M. Evaluation of Annealing Process of Polycarbonate Sheet to Remove the Residual Stresses. Modares Mechanical Engineering 2013; 13 (6) :103-113
URL: http://mme.modares.ac.ir/article-15-9287-en.html
Abstract:   (4960 Views)
In this paper, annealing processes for stress relaxation and removing residual stresses from polycarbonate sheet are studied and evaluated using experimental tests. Then, by making some alterations and modifications in the previous heating cycles thermal operations are performed on different samples in a try and error process. Appraising the obtained results, a modified thermal cycle is presented which can remove the residual stress from the polycarbonate sample, while reducing the time and cost of the annealing process. According to this process, the temperature is raised to 100˚C at the heating rate of 20˚C/h. The samples are kept at this temperature for 3 hours and then, the heating is continued up to 140˚C at a slower rate of 5˚C/h. Then, the specimens are heated at the rate of 1˚C/h until maximum temperature of Tmax = 156˚C. After reaching this point, the samples are cooled immediately, and the cooling rates are same as the heating rates.
Full-Text [PDF 739 kb]   (5725 Downloads)    
Article Type: Research Article | Subject: Stress Analysis
Received: 2012/10/7 | Accepted: 2013/02/23 | Published: 2013/07/6

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.