Volume 14, Issue 1 (2014)                   Modares Mechanical Engineering 2014, 14(1): 97-105 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Investigation on Performance of Ultra Fine Grained Pure Copper as Electrode during Electrical Discharge Machining. Modares Mechanical Engineering. 2014; 14 (1) :97-105
URL: http://journals.modares.ac.ir/article-15-9385-en.html
Abstract:   (3185 Views)
One of the fundamental problems of Electrical Discharge Machining (EDM) process is tool electrode wear. In this study, ultra fine grains (UFG) structure of pure copper was used to improve performance and also increase the electrical wear resistance of tool electrode. Equal Channel Angular Pressing (ECAP) was used to reduce the crystal size of pure copper. Samples were processed through ECAP die up to 8 passes, and then used as electrode in EDM process. The effect of electrodes grain size, discharge current, and machining time on the metal removal of the work piece and electrical wear of the electrodes were investigated. In addition, the microstructure, and electrical conductivity of copper tool electrodes were examined. By applying the ECAP on pure copper a fine, approximately 50-200 nm grain size, microstructure was obtained after 8 passes. The results show that for finer crystalline structure of copper electrodes, electrical wear decreases but material removal rate is somehow constant.
Full-Text [PDF 1238 kb]   (1567 Downloads)    
Article Type: Research Article | Subject: Manufacturing Methods|Micro & Nano Systems|Metal Forming|Characterization, Analysis & Selection of Materials
Received: 2013/07/23 | Accepted: 2013/09/30 | Published: 2014/01/25

Add your comments about this article : Your username or Email:
CAPTCHA