TY - JOUR T1 - Ultrasonic assisted magnetic abrasive finishing of inner surface of tube TT - بررسی تجربی پرداختکاری سایشی مغناطیسی به کمک ارتعاشات التراسونیک بر روی سطح داخلی قطعه‌کار لوله‌ای شکل JF - mdrsjrns JO - mdrsjrns VL - 17 IS - 5 UR - http://mme.modares.ac.ir/article-15-9181-en.html Y1 - 2017 SP - 103 EP - 110 KW - Magnetic abrasive finishing KW - Ultrasonic vibrations KW - Mesh number KW - Optical microscopy N2 - Ultrasonic Assisted Magnetic Abrasive Finishing (UAMAF) is the combination of magnetic abrasive finishing (MAF) and ultrasonic vibrations to finish the surfaces in nanometer scale. In this work, the experimental setup for UAMAF was prepared to finish inner surface of tube workpiec. By using experimental setup, the effect of experimental parameters such as ultrasonic vibrations, mesh number, the type of abrasives (SiC and diamond) and finishing time has been investigated on the changes in the surface roughness of AL6061 tube workpiece. The experimental results showed that the use of ultrasonic vibrations has a significant effect on reducing the surface roughness. The changes in surface roughness increases with the mesh number from 90 to 800 and finishing time from 30s to 5 min. Among two types of abrasives, diamond showed the best performance in finishing. Optical microscopy images showed that the dominant finishing mechanism in MAF for coarse grains (with mesh size of 90 and 120) is two body and for fine grains (with mesh size of 220, 400 and 800) is three body. In UAMAF for both of the coarse and fine grains the dominant finishing mechanism is three body. M3 ER -