Modares Mechanical Engineering
مهندسی مکانیک مدرس
Modares Mechanical Engineering
Engineering & Technology
http://mme.modares.ac.ir
1
admin
1027-5940
2476-6909
10.22034/mme
fa
jalali
1397
2
1
gregorian
2018
5
1
18
3
online
1
fulltext
fa
مدلسازی و صحه سنجی پاسخ یک حسگر گاز تحت مدولاسیون دمایی به گاز اتانول
Modeling and validation of the transient response of a temperature modulated gas sensor to ethanol
در این مقاله ابتدا یک حسگر گاز اکسید فلزی از نوع تجاری تحت مدولاسیون دمایی قرار داده شده و همزمان ثبت پاسخهای گذرای آن به تراکمهای مختلف گاز اتانول ارائه میشود. با اعمال مدولاسیون دمایی، دمای سطح حسگر نیز توسط یک ترموکوپل نوع-S ظریف ثبت شد. سپس عملکرد این نوع حسگرها بر اساس مدل جذب اکسیژن هوا و جذب گاز اتانول بر سطح لایه حساس با استفاده از معادله جذب همدمای فروندلیش بیان میشود. در ادامه، این مدل با استفاده از نرم افزار متلب در محیط سیمولینک شبیهسازی میشود. با استفاده از این مدل میتوان پاسخ پویای حسگر را به اتانول مشاهده کرد. در این مدل، تراکم یک گاز بصورت ولتاژ در نظر گرفته میشود. این پارامتر به همراه پروفایل دمایی سطح یک حسگر تحت مدولاسیون دمایی و هدایت حسگر تحت تاثیر اکسیژن هوا، به عنوان ورودیهای مدل و پاسخ گذرای حسگر به عنوان خروجی مدل در نظر گرفته میشوند. پارامترهای این مدل بر اساس معیار نزدیکی پاسخهای شبیهسازی شده و پاسخهای ثبت شده در هر تراکم از گاز اتانول محاسبه میشوند. نتایج شبیهسازی بر اساس میانگین پارامترهای شبیهسازی شده نیز نشاندهندهی نزدیکی پاسخهای شبیهسازی شده و پاسخهای ثبتشدهی واقعی بود.
In this paper, a commercial metal-oxide gas sensor was first placed under temperature modulation regime and simultaneously their transient response to various concentrations of ethanol vapors was recorded. By applying the temperature modulation, the sensor surface temperature was also recorded by a S-type thermocouple. Then, the performance of these sensors was expressed based on the both air oxygen absorption model and ethanol absorption on the surface of the sensitive layer using the Freundlich isotherm equation. Further, this model is simulated using the MATLAB software in the simulink environment. Using this model, one can see the sensor's dynamic response to ethanol. In this model, the concentration of a gas is considered as a voltage. This parameter, along with the temperature profile of the sensor surface under temperature modulation and sensor conductance under the influence of air oxygen, are considered as inputs of the model and transient response of the sensor as output of the model. The parameters of this model are calculated based on the approximate criterion of simulated responses and the responses recorded for each concentration of ethanol gas. The simulation results based on the average simulated parameters also showed that the simulated responses were close to the actual recorded responses.
حسگر گاز اکسید فلزی, سیمولینک متلب, مدولاسیون دمایی, پاسخ گذرا
Metal oxide gas sensor؛ MATLAB Simulink؛ Temperature modulation؛ Transient response
164
170
http://mme.modares.ac.ir/browse.php?a_code=A-15-22237-1&slc_lang=fa&sid=15
Seyed Mohsen
Hosseini-Golgoo
سیدمحسن
حسینی گلگو
1003194753284600231175
1003194753284600231175
Yes
Electrical Engineering, Engineering Faculty, University of Guilan, Rasht, Iran
گروه مهندسی برق، دانشکده فنی، دانشگاه گیلان، رشت، گیلان
Sajjad
Sabet
سجاد
ثابت
1003194753284600231176
1003194753284600231176
No
Electrical Engineering, Engineering Faculty, University of Guilan, Rasht, Iran
گروه مهندسی برق، دانشکده فنی، دانشگاه گیلان، رشت، ایران