Volume 17, Issue 10 (1-2018)                   Modares Mechanical Engineering 2018, 17(10): 242-248 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Rezaei H, Sadeghi M H, Khosroabadi H. An Experimental study into the size effect in micromilling process. Modares Mechanical Engineering. 2018; 17 (10) :242-248
URL: http://mme.modares.ac.ir/article-15-1931-en.html
1- Tarbiat Modares University
2- maintenance manager of Ph 20&21 in South Pars Gas Complex
Abstract:   (2529 Views)
Micro end-milling is one of the main manufacturing processes of creating miniaturized parts which are increasingly demanded in many industries. Using tools with diameter less than 1 mm results in rising the so-called “size effect” and problems due to ploughing at low feeds per tooth. It is therefore crucial to estimate value of minimum chip thickness which helps to reduce or eliminate the ploughing. In this study role of scaling down is investigated with regard to milling operation in micro- and macro-scale. A titanium alloy Ti-6Al-4V is used as workpiece. Two-flute endmills with diameters of 0.8 and 2 mm are used representing micro and macro-scale, respectively. Effects of axial depth of cut and feed rate as input parameters were evaluated on such output characteristics as specific cutting energy, microhardness, surface roughness, topography and chip formation. Results show higher values of microhardness and specific cutting energy in micro-scale. Microhardness and specific cutting energy in micro-scale were found to be 6 times and 150% greater than the macro-scale, respectively. The study suggests that minimum chip thickness can be varied approximately between 0.25 and 0.49 of the cutting edge radius.
Full-Text [PDF 1248 kb]   (3623 Downloads)    
Article Type: Research Article | Subject: Manufacturing Methods
Received: 2017/07/12 | Accepted: 2017/09/20 | Published: 2017/10/20

Add your comments about this article : Your username or Email: