Volume 17, Issue 10 (1-2018)                   Modares Mechanical Engineering 2018, 17(10): 101-111 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Salimi Lafmejani A, Tale Masouleh M, Kalhor A. Position Control of a 6-DoF Pneumatic Gough-Stewart Parallel Robot Using Backstepping-Sliding Mode Controller. Modares Mechanical Engineering. 2018; 17 (10) :101-111
URL: http://mme.modares.ac.ir/article-15-4035-en.html
1- Research Assistant, TaarLab
2- Assistant Professor
Abstract:   (3171 Views)
In this paper, position control is addressed for a pneumatically actuated 6-DoF Gough-Stewart parallel robot. At first, dynamic model of the pneumatic system of each link of the robot which comprises a pneumatic actuator and a proportional electrical control valve is extracted. Unknown parameters of the obtained dynamic model consisting friction force, viscous coefficient and the parameters of the valve are identified by employing an evolutionary algorithm. Then, position control of the robot’s pneumatic actuator is performed based on designing Backstepping-Sliding Mode controller according to the nonlinear dynamic model of the pneumatic system. Moreover, kinematic equations of the 6-DoF parallel robot are achieved and a novel method is proposed, the so-called Geometry-based Quasi-Forward Kinematic, to the end of calculating the position of the end-effector of the robot without using expensive position sensors. Accordingly, kinematic closed-loop control of the parallel robot, which is based on simultaneous joint space and task space control, is investigated for trajectory tracking using potentiometers, a rotation sensor, and based on the computed position of the end-effector by the proposed method. Desired sinusoidal trajectories with pure motions and also complicated trajectories are tracked in which error of positions and rotations are lower than 2 (cm) and 3 (deg), respectively. The results reveal that the trajectory tracking control of the pneumatic 6-DoF Gough-Stewart parallel robot is performed properly based on the proposed control strategies and the novel method for calculating the position of the end-effector.
Full-Text [PDF 1326 kb]   (4537 Downloads)    
Article Type: Research Article | Subject: robatic
Received: 2017/06/27 | Accepted: 2017/08/28 | Published: 2017/10/5

Add your comments about this article : Your username or Email: