Volume 21, Issue 7 (July 2021)                   Modares Mechanical Engineering 2021, 21(7): 469-478 | Back to browse issues page

XML Persian Abstract Print


1- Shahid Rajaee Teacher Training University, Lavizan, Tehran, Iran
2- Shahid Rajaee Teacher Training University, Lavizan, Tehran, Iran , v.panahizadeh@sru.ac.ir
Abstract:   (240 Views)
Cold work hardening and nonlinear strain path, cause the failure strain change. Therefore, it is necessary to consider the created cold-work hardening and its distribution for predicting and simulating the behavior of products. The composite rupture disc cold-work hardened during manufacturing and burst and release pressure in a pressure commensurate with this hardening. In this case, the sheet metal undergoes a nonlinear strain path during forming and after slotting during the burst test. In this paper, the burst pressure of a composite Rupture disc estimated by using finite element simulation in Abaqus-implicit and explicit and by considering the strain hardening during bulge forming before the slotting process. The burst pressure is estimated according to the maximum plastic failure strain that changed due to nonlinear strain path and work hardening. The burst pressure predictions were compared and validated by experimental tests. In this paper, the effect slotting pattern, investigated by using FEM simulations and experiments. In the prepared samples for this paper, by slotting after bulge forming, the burst pressure reduces more than 80%. The simulation with this method predicts this pressure reduction with an error of about 3%.
Full-Text [PDF 956 kb]   (80 Downloads)    
Article Type: Original Research | Subject: Forming of metal sheets
Received: 2021/04/8 | Accepted: 2021/05/11 | Published: 2021/07/1