---

Vibration waves with frequencies greater than 20 kHz, known as ultrasonic vibrations, are used in many manufacturing and engineering processes. This paper studies the occurrence of acoustic softening in steel specimens with three different microstructures. For this purpose, specimens with bainite and martensitic microstructures were created by Austempering and Quench heat treatments. The final dimensions of these specimens were obtained with Modal finite element analysis using ANSYS software so that the resonance frequency of the specimen is equal to the resonance frequency of transducer. Given that ultrasonic vibration induces a tension called vibrational stress to the crystal, this stress causes movement of dislocations and reduces the yield strength of specimens. In this paper 55 w / cm2 ultrasonic vibration, 18%, 12% and 8% yield strengths of specimens are reduced with ferrite- perlite, bainite and martensitic microstructure. Due to the absorption of vibrational energy by dislocation, the metal forming of these materials takes place with less energy. Also, in this paper, a numerical model for acoustic softening was investigated and it was found that there is a good correlation between numerical modeling and experimental e results.

---

The main purpose of this paper is to reveal the volume effect of ultrasonic vibrations on the plastic behavior of S355J2 steel specimens with different grain sizes and investigate the decrease in the Yield strength and ultimate strength of these steel specimens. For this study, samples of grain size of 10, 35 and 60 microns were created by performing various cycles of normalization and annealing heat treatments. An experimental setup was designed and developed for the tensile test with ultrasonic vibration. The tensile test was carried out at a room temperature and constant speed of 1 mm /min and it was found that by applying 390 watts of vibrations, the yield strength reduction of steel specimens with a grain size of 10, 35 and 60 microns was 8%, 18% and 27%, respectively. . The grain boundary length in fine-grain specimens is greater than the largest-grain specimens, therefore, the sound energy is distributed over the boundary. Therefore, the effect of applying ultrasonic vibrations on fine-grain specimens is less than that of largest grains and the yield strength and ultimate strength of fine-grain specimens showed a lower reduction