---

In conventional internal combustion engines, about 40% of fuel energy is turned into useful power and the rest is driven by cooling and exhaust system out of the engine. Therefore, there is a ground to recover energy from this wasted energy by fixing an additional cycle inline with the exhaust gas outlet. In this research, a stirling cycle was used for this purpose. Initially, the internal combustion engine was simulated. The engine studied was an EF7-NA spark ignition internal combustion engine and the simulation results were validated by using experimental results. The results showed that the exhaust gas outlet temperature varies from 393 to 848 ° C, according to engine operating conditions. Therefore, by installing a Stirling engine heater inline with the exhaust gases from the EF7 engine, the wasted energy can be turned into useful work. To validate the results of one-dimensional Stirling engine simulation, the experimental results of the Stirling Solo V161 engine were used. After validating the Stirling engine model, the combined cycle was simulated, combining a Stirling engine at working pressure of 50, 60 and 70 bar and EF7 engine at engine speed of 2000 to 4500 rpm. The results showed that at an optimal pressure of 50 barfor the Stirling engine, the EF7 power gain was 12.2% and an average efficiency increase of 5.2%, regardless of the weight of the added stirling engine in the car which considering that, a low impact on the power of the combined cycle is expected.

---

Waste heat recovery systems, which make use of waste sources for their input energy, have considerable importance in industry since they utilize streams, which will be disposed to nature if not employed. Ship’s engines are one of the places, where a large amount of energy is wasted in different forms. In the present article, the idea of making use of these loss streams and consequently producing useful power in the outlet is proposed in the form of two systems. In the first system, the only stream of exhaust gases is utilized, while in the second system, the jacket cooling water is used together with the engine exhaust gases. Screening in the working fluids is conducted in order to select appropriate fluids, which have suitable characteristics in the physical, safety, and environmental aspects. The analyses indicate that using R600a presents the highest net power output, which reaches to the value of about 575 kW at the most. Comparison of the two introduced systems shows that preheating the working fluid by the jacket cooling water makes the better operation of the system and the power output is increased up to about 31-58% in different fluids. The lowest payback period in the systems is achieved through the use of R600a as the working fluid, which is about 3.48 year in the second system.