%0 Journal Article
%A Hosseini, Seyed Farhad
%A Moetakef-Imani, Behnam
%A Hadidi Moud, Saeid
%T Construction of smooth B-spline surfaces based on improving data point distribution
%J Modares Mechanical Engineering
%V 14
%N 13
%U http://mme.modares.ac.ir/article-15-381-en.html
%R
%D 2015
%K B-spline curve, B-spline surface, Lofting, Common knot vector,
%X The need for complex surfaces in CAD motivates researchers for methods which can produce smooth and visually pleasing surfaces. In this research, a new method is presented for creating compatible cross-sectional curves for surface fitting to certain sections or lofting. In this method, the distribution of sections' data points along with basis knot vectors are improved in order to reach a desired smooth surface. In compatibility process, the section curves' degrees and their knot vectors must be set equal before implementing lofting process. Based on proposed algorithm, in this research, the constructed smooth and faired surfaces can be used in many engineering applications such as reverse engineering, biomedical engineering, quality control, etc. The main focus of the method is improvement of data points' distributions and their assigned parameters in a way that by a few iterations, data points' distribution are improved in order to reach a common knot vector for all cross-sectional curves. The method is implemented on some benchmarking examples and its efficiency are confirmed. In addition, the amount of final data points' deviation from the initial section curve is analyzed using the vigorous Hausdorff method. It is worth mentioning that the quality of obtained final surface is visually pleasing. In order to quantitatively confirm that the proposed method will result in smooth and fair surfaces, MVS is used. Finally the application of the method in modeling the root joint zone of a wind turbine blade is presented.
%> http://mme.modares.ac.ir/article-15-381-en.pdf
%P 27-36
%& 27
%!
%9
%L A-15-1000-288
%+
%G eng
%@ 1027-5940
%[ 2015