Volume 10, Issue 2 (9-2010)                   Modares Mechanical Engineering 2010, 10(2): 19-30 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

NasrAbadi M, Sadeghi M, Motakef. Imani B. Cutting dynamic simulation of Low Immersion End Milling Operation: Effect of cutting depth and feed rate. Modares Mechanical Engineering 2010; 10 (2) :19-30
URL: http://mme.modares.ac.ir/article-15-11403-en.html
1- Tarbiat Modares University
2- , Tarbiat Modares University
3- Ferdowsi University of Mashad
Abstract:   (10506 Views)
In end milling operation, cutting forces induce vibration on tool, workpiece and clamping devices which affects surface integrity and quality of the product. In this process, to select the optimum end mill and machine tool, the prediction of exact cutting forces is of prime importance. In the present work, modeling and simulation of cutting forces in end milling operation are performed. Instantaneous chip geometry is predicted using a 3D simulation software, the effect of cutting depth and feed rate are calculated and cutting conditions are predicted before any machining operation.
Full-Text [PDF 1012 kb]   (7248 Downloads)    

Received: 2007/10/23 | Accepted: 2008/10/31 | Published: 2010/09/7

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.