Volume 17, Issue 12 (2-2018)                   Modares Mechanical Engineering 2018, 17(12): 266-274 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Alaviyoun S S, Ziabasharhagh M. Experimental thermal investigation of turbocharger in internal combustion engine and considering effect of electrical water pump on heat soak test. Modares Mechanical Engineering 2018; 17 (12) :266-274
URL: http://mme.modares.ac.ir/article-15-11456-en.html
1- Faculty of Mechanical Engineering, Khaje Nasir Toosi University of Technology
2- Associate Professor
Abstract:   (3874 Views)
In the past years many research efforts on turbocharger heat transfer have been performed, however, there are not enough investigations on unsteady condition of turbocharger. One of the unsteady condition is heat soak test. In this test, engine runs at maximum power until all temperatures are stabilized, then the engine stops suddenly. After the engine has been shut down, heat stored in the turbine housing soaks back into the bearing housing of the turbocharger. This heat can potentially destroy the bearing system and the oil-sealing piston rings. The aim of the paper is to investigate the effect of turbocharger temperature distribution in heat soak test and considering effect of electrical water pump on temperature distribution. Experimental investigation has been performed on gasoline engine turbocharger, which several thermocouples have been used on accessible surfaces of the turbocharger. Turbine, compressor and bearing housings temperature have been measured inside engine test cell. Moreover, temperature, pressure and flow rates of oil, water and air have been measured. Results of engine heat soak test with original cooling circuit, show that bearing housing temperature increases 60°C after engine shutdown and maximum temperature reaches 220°C. However, using electrical water pump after engine shutdown causes only 10°C incensement of bearing housing temperature.
Full-Text [PDF 1492 kb]   (8833 Downloads)    
Article Type: Research Article | Subject: Internal Combustion Engine
Received: 2017/09/12 | Accepted: 2017/11/12 | Published: 2017/12/15

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.