Volume 16, Issue 5 (7-2016)                   Modares Mechanical Engineering 2016, 16(5): 135-144 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Shamsborhan M, Moradi M, Shokuhfar A. Numerical optimization of “Planar twist channel angular extrusion” as a novel severe plastic deformation method by DOE method. Modares Mechanical Engineering 2016; 16 (5) :135-144
URL: http://mme.modares.ac.ir/article-15-12030-en.html
1- Asistant professor of engineering faculty of Islamic Azad university- Mahabad branch
Abstract:   (5148 Views)
The most successful ‘‘top–down’’ approach to produce bulk ultra-fine grained or nanostructured materials involves the use of severe plastic deformation (SPD) processing. The amount of higher effective plastic strain per pass plays a key role on the final microstructure of SPD processed samples. In the present study the numerical experiments of the combination of the equal channel angular pressing (ECAP) and simple shear extrusion (SSE) as a new process entitled “planar twist channel angular extrusion (PTCAE)” was performed based on the Response Surface Methodology (RSM), as a statistical design of experiment approach, in order to investigate the effect of parameters on the response variations, achieving the mathematical equations, predicting the results to impose higher effective plastic strain values. Α and ϕ angles, radius and friction coefficient was imposed as the input parameters while average, minimum and maximum effective strain and maximum load was imposed as the output parameters. Governing regression equations obtained after analysis of the simulation data by Minitab software. Optimum process parameters are: α=450, Φ =450, r=2 mm and µ=0.1. Verification of the optimum results using simulation experiment was done. Good agreement between simulation, experimental and optimization was occurred.
Full-Text [PDF 926 kb]   (5700 Downloads)    
Article Type: Research Article | Subject: Finite Elements Method
Received: 2015/12/12 | Accepted: 2016/03/5 | Published: 2016/05/16

Add your comments about this article : Your username or Email:

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.