Volume 23, Issue 7 (July 2023)                   Modares Mechanical Engineering 2023, 23(7): 405-414 | Back to browse issues page

‎ 10.22034/mme.23.7.405
‎ 20.1001.1.10275940.1402.23.7.2.6

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Rasti A, Yazdani Khameneh M. Experimental Analysis of Residual Stresses Distribution Using Nano indentation Method in Hole Making Strategies. Modares Mechanical Engineering 2023; 23 (7) :405-414
URL: http://mme.modares.ac.ir/article-15-69590-en.html
Experimental Analysis of Residual Stresses Distribution Using Nano indentation Method in Hole Making Strategies
Amir Rasti * 1, Mohammad Yazdani Khameneh2
1- Department of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran , a.rasti@modares.ac.ir
2- Department of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran
Abstract:   (1923 Views)
 In this study, variations in the residual stresses distribution were studied in different hole-making strategies including; conventional, multi-step drilling and helical milling. Residual stresses were measured for 12 perforated samples made of 4340AISI steel, using nanoindentation method. The results showed the highest near-surface compressive residual stress in the multi-step drilling (up to 373.5 MPa). Also, due to the phase transformation on the surface, the effect of plastic work was eliminated and tensile residual stresses up to a maximum of 114.7 MPa were measured in the drilling process. On the other hand, decreasing the cutting speed and increasing the feed rate raised the compressive stresses up. The trend exception was formation of the white layer in the drilling process. Comparison of the stresses measured on the reference sample also showed a difference of about 28.6% between the two methods of XRD and nanoindentation, which shows an acceptable repeatability of the measurement using nanoindentation method.
 
Keywords: Drilling Process, Residual Stresses, Nanoindentation Method, XRD Method
Full-Text [PDF 1246 kb]   (621 Downloads)    
Article Type: Original Research | Subject: Machining
Received: 2023/06/3 | Accepted: 2023/06/26 | Published: 2023/07/1
Add your comments about this article : Your username or Email:
CAPTCHA
Send email to the article author

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.