Volume 17, Issue 1 (3-2017)                   Modares Mechanical Engineering 2017, 17(1): 263-272 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Afshari A, Dehghan A, Kalantar V, Farmani M. Experimental investigation of surface pressure spectra beneath turbulent boundary layer over a flat plate with microphone. Modares Mechanical Engineering 2017; 17 (1) :263-272
URL: http://mme.modares.ac.ir/article-15-8508-en.html
1- student
2- associate professoryazd university
3- phd student/yazd university
Abstract:   (4328 Views)
Surface pressure fluctuations beneath turbulent boundary layer on a flat plate have complex physical behavior and due to its importance in acoustic noise generation, extensive studies have been devoted to predicting or measuring the surface pressure behavior. In the present study to investigate the surface pressure fluctuations under zero pressure gradient, a flat plate with a chord length of 580 mm has been used. All experiments were carried out in a subsonic wind tunnel and at three free-stream velocities: 10, 15 and 20 m/s. In order to measure unsteady pressure fluctuations, a condenser microphone is used as a pressure transducer. Moreover, various parameters of turbulent boundary layer are measured to provide the input variables of semi-empirical models. A single constant temperature hot-wire anemometer has been used for boundary layer measurement. Surface pressure spectra has been measured at various velocities and their collapse on a single curve by normalizing with different variables of turbulence boundary layer is studied. The results show that the best collapses in low and middle frequencies can be obtained by using mixed variables. However, in high frequency range the pressure spectra collapses when it is normalized by inner layer scales. Finally, after ensuring the accuracy of surface pressure spectra results, the efficiency of semi-empirical models for predicting turbulent boundary layer wall pressure spectra is evaluated. The results show the effectiveness of the Goody’s semi-empirical model for prediction of surface pressure spectra by using turbulent boundary layer parameters.
Full-Text [PDF 1418 kb]   (6301 Downloads)    
Article Type: Research Article | Subject: Aerodynamics
Received: 2016/10/26 | Accepted: 2016/12/24 | Published: 2017/01/15

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.