Drying process is influenced by a variety of parameters including the geometry of part being dried. To evaluate the effect of part geometry on drying process, and resultant defects, the process is analyzed and studied. Based on the assumption related to the porous media the governing equation of the mass transfer and static equilibrium are presented. The mechanical stresses generated by the drying strains are expressed according to the linear-elastic model. Dependence of physical and mechanical properties such as Young's modulus and diffusion coefficient as a function of moisture are considered in simulation for a chemically known ceramic material. it’s Assumed that Extended thin film evaporation is the mechanism of evaporation in constant rate period has been studied. The Von Misses criterion is used for crack anticipation in 2D and 3D drying. A significant difference was observed in possibility of crack initiation for the two different configurations. Yield stress in hygroscopic moisture has been determined experimentally. Developed model made it possible to predict the time and the place of crack initiation. Different part thicknesses were studied to examine the effect of thicknesses variations on cracking. It is observed that the danger of cracking is highest at the beginning of the drying, since the yield stress is low.