مهندسی مکانیک مدرس

مهندسی مکانیک مدرس

مطالعه میدانی ابعاد درز درب و پنجره‌های رایج ایران و پیشنهاد روابط محاسبه نفوذ هوا از آن‌ها

نویسندگان
1 دانشجوی کارشناسی ارشد دانشگاه تربیت مدرس تهران
2 دانشگاه تربیت مدرس
3 مرکز تحقیقات راه مسکن و شهرسازی
چکیده
مطالعه نفوذ هوا به ساختمان از چند دیدگاه همچون مصرف انرژی، کیفیت هوا، آسایش حرارتی و ورود آلودگی به ساختمان اهمیت بسیاری دارد. در این زمینه پژوهش‌های بسیاری در کشورهای مختلف انجام شده‌ است. در کشور ما به دلیل استفاده از درب و پنجره‌های آهنگری‌ساز، انجام تحقیق مستقل در خصوص اندازه درزها و نفوذ هوا ضرورت دارد. در این پژوهش با دیدگاهی کاربردی و به منظور بومی‌سازی نتایج، بر اساس مطالعه میدانی، ابعاد واقعی انواع درزهای اطراف درب و پنجره‌های رایج در ایران اندازه‌گیری شده است. نتایج این اندازه‌گیری برای شبیه‌سازی درزها استفاده شده و سپس به صورت تجربی نرخ نفوذ هوا از این درزها در اختلاف فشارهای مختلف محاسبه شده است. در تحقیق حاضر پس از بررسی تأثیر ابعاد مختلف درز بر نرخ نفوذ هوا، دو معادله رایج توانی و درجه دوم برای برازش داده‌ها مورد مقایسه قرار گرفتند. نتایج نشان می‌دهد که معادله توانی تطابق بهتری با داده‌های تجربی دارد. ضرایب لازم معادله توانی برای برآورد نرخ نفوذ هوا از انواع درزهای موجود در درب و پنجره‌های رایج ایران ارائه شده است. همچنین با تحلیل نتایج بدست آمده، با توجه به نزدیکی توان اختلاف فشار به عدد 0.5 در اکثر نتایج، نتیجه گرفته شد که از معادله برنولی نیز می‌توان برای پیشبینی نرخ نفوذ هوا از درزها استفاده کرد. این رابطه با قوانین و اصول فیزیکی تطابق بهتری دارد. ضریب تخلیه مربوط به معادله برنولی برای درزها با ابعاد مختلف محاسبه شده است.
کلیدواژه‌ها

عنوان مقاله English

Field study of gap dimensions around conventional doors and windows in Iran and relations for calculating air infiltration of them

نویسندگان English

Danial Hakimi Rad 1
Mehdi Maerefat 2
Behruz MohammadKari 3
Hazhar Rasouli 2
1 M.sc Student, Department of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran
2 Tarbiat Modares University
3 Energy & Environmental Design, Building and Housing Research Center
چکیده English

Study air infiltration into the building in several ways such as energy, air quality, thermal comfort and pollution entering in the building is very important. In this context, many studies have been conducted in different countries. In our country due to the use of steel doors and windows, do independent research on the gap size and air infiltration is necessary .In this study, by practical view and in order to localize results, based on a field study, the actual dimensions of the gaps around conventional doors and windows in Iran is measured. The results of these measurements are used to simulate gaps, then with experimental study, air infiltration rate of this gaps is calculated at different pressures. In present study, after investigating the effect of different aspects of gaps on air infiltration rate, two common equations, power law and quadratic equation, in order to fitting data were compared. Results show that power law equation can adapt better to the experimental data. Coefficients of the power law equation to estimate the air infiltration rate through the gaps was presented. By analysis of the results, due to the proximity factor of the pressure difference to the number 0.5 in most of the results, it was concluded that the Bernoulli equation can be used to predict the air infiltration rate through the gaps. This equation is better compliance with laws and physical principles. Discharge coefficient of the Bernoulli equation for gaps with different dimensions are calculated.

کلیدواژه‌ها English

Air infiltration
Gaps around doors and windows
pressure difference
Experimental Study