Volume 17, Issue 12 (2-2018)
Modares Mechanical Engineering 2018, 17(12): 21-32 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
barghikar H, Mosadegh P, Ranjbar M, Masoomi M. Investigation and simulation of geometric and optical quality for bi-convex lens produced by injection molding process. Modares Mechanical Engineering 2018; 17 (12) :21-32
URL: http://mme.modares.ac.ir/article-15-7215-en.html
URL: http://mme.modares.ac.ir/article-15-7215-en.html
1- isfahan university on technologyIsfahan, Iran
2- Member of board, Department of mechanical engineering, Isfahan university of technology, Isfahan, Iran
3- Member of board, Department of Physics, Isfahan university of technology, Isfahan
4- Member of board, Department of chemical engineering, Isfahan university of technology, Isfahan, Iran
2- Member of board, Department of mechanical engineering, Isfahan university of technology, Isfahan, Iran
3- Member of board, Department of Physics, Isfahan university of technology, Isfahan
4- Member of board, Department of chemical engineering, Isfahan university of technology, Isfahan, Iran
Abstract: (7191 Views)
This study investigates the effect of injection parameters on the geometric and optical quality of a Bi-convex lens injected with PMMA polymer. An important part of this research is the effect of each parameter on the geometric and optical quality of the lens and the obtaining of optimal quantities for injection. According to the results of this study, the effective factors simultaneously on the geometric quality and the optical quality of these types of lenses are melt temperature, packing time, injection pressure and packing pressure, respectively. These factors indicate that the simultaneous control of the pressure, in the mold cavity both during the injection and at the packing stage, can represent a suitable injection with minimal optical errors. According to the collected data, the average volumetric shrinkage check is 5.847% singly, in this case the refractive index is equivalent to 7.12E-05. The refractive index analysis is 6.28E-05 singly. In this case, the minimum average volume contraction is 9.1%. Therefore, optimizing and minimizing one of the geometric or optical factors will not produce the proper values of the other factor. Using the multi response Taguchi method, is obtained the minimum average volumetric shrinkage is 5.503% and the minimum refractive index is 6.96E-05.
Article Type: Research Article |
Subject:
other......
Received: 2017/08/3 | Accepted: 2017/10/12 | Published: 2017/12/1
Received: 2017/08/3 | Accepted: 2017/10/12 | Published: 2017/12/1
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |