Volume 23, Issue 10 (October 2023)                   Modares Mechanical Engineering 2023, 23(10): 43-49 | Back to browse issues page


XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Amini S, Saebirad R. Experimental Investigation of The Effect of Changes in the Machining Parameters of the Turn-Milling Process. Modares Mechanical Engineering 2023; 23 (10) :43-49
URL: http://mme.modares.ac.ir/article-15-72714-en.html
1- , amini.s@kashanu.ac.ir
Abstract:   (1302 Views)
Turn-milling is a new process that uses, turning and milling operations together, so that the tool and the work piece rotate simultaneously, for this reason, it has a wide ability in machining curved and complex surfaces. The Main subject of this research is Conducting research on the effect of changes in machining parameters, including work piece rotational speed, tool rotational speed and feed rate, on cutting parameters such as cutting force, cutting pressure, and surface finish parameters. The order and the number of experiments is designed based on the full factorial method. Experiments for each of the mentioned parameters were performed at three levels, which includes 27 tests in total. The results were analyzed with the help of Minitab software. The mentioned process was performed with a φ6 diameter end mill on a steel work piece 1.7225. As a result, increasing feed rate by three times increases the machining force by about two times and reduces the cutting pressure by about 27%, Also, the surface finish quality parameters R a  and R z  increased by 74% and 61%, respectively. The upward or downward trend of cutting forces, cutting pressure and the surface finish quality did not occur with the increase in the rotational speed of the work piece and the rotational speed of the tool, in fact, an extremum range was achieved in the increasing trend of the mentioned speeds. So that the minimum resultant force and also the cutting pressure were observed in the range of rotational speed of 950rpm of the tool and 300rpm of the work piece.
Full-Text [PDF 784 kb]   (1115 Downloads)    
Article Type: Original Research | Subject: Machining
Received: 2023/12/1 | Accepted: 2023/10/2 | Published: 2023/10/2

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.