Modares Mechanical Engineering

Modares Mechanical Engineering

Numerical simulation and optimum operational point determination of a downdraft gasfier regarding pollutant emissions

Authors
ali bahari
javad mahmoudimehr
Department of Mechanical EngineeringFaculty of EngineeringUniversity of GuilanP.O.Box 3756, Rasht, Iran.
Abstract
The use of biomass by means of gasification to produce bio fuels and reducing the environmental impact of fossil fuels has been the focus of many researchers in recent years. In the present study, the computational fluid dynamics method is used to predict the process of gasification inside a downdraft gasifier. Recent studies have shown that although many studies have been carried out by various researchers to maximize the cold gas efficiency in the gasification process, so far, no study has been done to minimize the emission of pollutants as one of the other important design parameters along with the increase of cold gas efficiency. So, in this study, the effect of changing the equivalence ratio as design variable on the gasification efficiency as well as the amount of pollutant produced simultaneously is investigated. Also, in this study, CO/CO2 and H2 /H2O molar ratios are considered as another objective function in selecting the optimal process point. In order to verify the validity of the results, the simulation data was compared with the experimental results and the previous numerical study, and a good agreement was shown between their comparison. The results of this study show that in the ratio of 0.64, the rate of production of nitrogen oxides relative to cold gas efficiency is optimal considering the maximum production of CO/CO2 and H2/H2O molar ratios . This point is the optimal point. Under the working conditions of the gasification process.
Keywords
Gasification
Syngas production
Downdraft gasifier
Numerical simulation

Subjects

[1] N. S. Barman, S. Ghosh, and S. De, Gasification of biomass in a fixed bed downdraft gasifier - A realistic model including tar,Bioresour. Technol., Vol. 107, pp. 505–511, 2012.
[2] F. Centeno, K. Mahkamov, E. E. Silva Lora, and R. V. Andrade, Theoretical and experimental investigations of a downdraft biomass gasifier-spark ignition engine power system, Renew. Energy, Vol. 37, No. 1, pp. 97–108, 2012.
[3] P. Meenaroch, S. Kerdsuwan, and K. Laohalidanond, Development of Kinetics Models in Each Zone of a 10 kg / hr Downdraft Gasifier using Computational Fluid Dynamics, Energy Procedia, Vol. 79, pp. 278-283, 2015.
[4] T. K. Patra and P. N. Sheth, Biomass gasification models for downdraft gasifier: A state-of-the-art review, Renew. Sustain. Energy Rev., Vol. 50, pp. 583–593, 2015.
[5] H. Stadler, D. Toporov, M. Förster, and R. Kneer, On the influence of the char gasification reactions on NO formation in flameless coal combustion, Combust. Flame, Vol. 156, No. 9, pp. 1755–1763, 2009.
[6] A. Slezak, J. M. Kuhlman, L. J. Shadle, J. Spenik, and S. Shi, CFD simulation of entrained- flow coal gasification : Coal particle density / size fraction effects, Vol. 203, pp. 98–108, 2010.
[7] A. Silaen and T. Wang, International Journal of Heat and Mass Transfer Effect of turbulence and devolatilization models on coal gasification simulation in an entrained-flow gasifier, Int. J. Heat Mass Transf., Vol. 53, No. 9–10, pp. 2074–2091, 2010.
[8] S. Khanmohammadi, K. Atashkari, and R. Kouhikamali, Performance assessment and multi-objective optimization of a trigeneration system with modified biomass gasification model, Modares Mech. Eng., Vol. 15, No. 9, pp. 209–222, 2015.
[9] B. Zhang, Z. Ren, S. Shi, S. Yan, and F. Fang, Numerical analysis of gasification and emission characteristics of a two-stage entrained fl ow gasifier, Vol. 152, pp. 227–238, 2016.
[10] M. Saiful Alam, A. T. Wijayanta, K. Nakaso, and J. Fukai, Study on coal gasification with soot formation in two-stage entrained-flow gasifier, Int. J. Energy Environ. Eng., Vol. 6, No. 3, pp. 255–265, 2015.
[11] W. Chen, C. Chen, C. Hung, C. Shen, and H. Hsu, A comparison of gasification phenomena among raw biomass , torrefied biomass and coal in an entrained-flow reactor, Appl. Energy, Vol. 112, pp. 421–430, 2013.
[12] X. Gao, Y. Zhang, B. Li, and X. Yu, Model development for biomass gasification in an entrained flow gasifier using intrinsic reaction rate submodel, ENERGY Convers. Manag., Vol. 108, pp. 120–131, 2016.
[13] ANSYS FLUENT 16.0 THEORY GUIDE, 2014.
[14] S. Badzioch and P. G. W. Hawksley, Kinetics of Thermal Decomposition of Pulverized Coal Particles, Ind. Eng. Chem. Process Des. Dev., Vol. 9, No. 4, pp. 521–530, 1970.
[15] I. W. Smith, The Combustion Rates of Coal Chars: A Review, 19th Symp. Combust., Vol. 19, No. 1, pp. 1045–1065, 1982.
[16] Y. Luan, Y. Chyou, and T. Wang, Numerical analysis of gasification performance via finite-rate model in a cross-type two-stage gasifier, Int. J. Heat Mass Transf., Vol. 57, No. 2, pp. 558–566, 2013.
[17] S. A. Morsi and A. J. Alexander, An Investigation of Particle Trajectories in Two-Phase Flow Systems, Journal of Fluid Mechanics, Vol. 55, No.2, pp. 193–208, 1972.
[18] J. W. E. Ranz and W. R. Marshall, Vaporation from Drops, Part I, Chem. Eng. Prog, Vol. 48(3), pp. 141–146, 1952.
[19] J. W. E. Ranz and W. R. Marshall, “Evaporation from Drops, Part I and Part II,” Chem. Eng. Prog., vol. 48(4), pp. 173–180, 1952.
[20] C. T. Crowe, M. P. Sharma, and D. E. Stock, The particle-source-in cell (PSI-CELL) model for gas-droplet flows, J. Fluids Eng., Vol. 99, No. 2, pp. 325–332, 1977.
[21] P. Basu, Gasification Theory. Elsevier Inc., 2013.
[22] S. Halama and H. Spliethoff, Numerical simulation of entrained fl ow gasification : Reaction kinetics and char structure evolution, Fuel Processing Technology, Vol. 138, pp. 314–324, 2015.
[23] Rex. T. L. Ng, D. H. S. Tay, W. Azlina, W. Ab, K. Ghani, and D. K. S. Ng, Modelling and optimisation of biomass fluidised bed gasifier, Apply thermal engineering, Vol. 61, pp. 98–105, 2013.
[24] N.Nipattamakul, S.Patumsawad, and S.Kerdsuwan, An Experimental investigation of a 15 kg / hr Downdraft Biomass Gasifier for Power Generation, International Conference of Engineering and Enviorment, pp. 40–42, 2007.
[25] L.LIINANKI and N.LINDMAN, Methane Yield from Biomass Gasification at High Temperature and Pressure, Royal Institute of Technology, pp. 923–924, 1985.
[26] M. Turns, An Introduction To Combustion: Concepts and Applications. 2000.
[27] M. Vaezi, M. Passandideh-Fard, M. Moghiman, and M. Charmchi, Gasification of heavy fuel oils: A thermochemical equilibrium approach, Fuel, Vol. 90, No. 2, pp. 878–885, 2011.
Modares Mechanical Engineering
Volume 18, Issue 6
October 2018
Pages 69-78