Modares Mechanical Engineering

Modares Mechanical Engineering

Geometrical Conditions Study to Select a Suitable Machining Strategy for Oval Gear

Authors
Mohammd Reza Sheykholeslami
Siamak Mazdak
Hamid Reza Mohammadi
Naser Meighani
10.22034/mme.23.10.245
Abstract
The mechanical flow meter is a widely used tool in various industries such as the oil industry. A pair of oval gears is used in the mechanical flow meter. The most important issue in the oval gear is the lack of uniformity in the shape of its teeth. This lack of uniformity prevents the gears from interfering with each other, for this reason, similar to the circular gear, it is not possible to machine. For the oval gear machining, tool design, or the use of the wire-cut method is required. As a result, it is necessary to know the profile of oval gear teeth. Therefore, in this article, the relations governing oval gears have been investigated. In these relationships, the number of teeth, geometric dimensions, and equations of motion have been investigated. Then, it was modeled using the Gear-Otix software and with the help of the results of the relationships of the gears, the interference conditions of the two gears were checked in this software, and finally, the stress analysis of the gear was done by using Comsol software for the appropriate state. With the help of the created model, it is possible to produce this gear using the wire-cut method.
Keywords
Oval Gear
Elliptic Gear
Stress Analysis
[1] پورآذری, خ., مهندسی معکوس چرخ‌دنده‌های بیضوی دبی‌سنج دنده‌ای با استفاده از تکنولوژی CAD/CAM. مهندسی مکانیک, 2020. 29(3): p. 60-65.
[2] Hong Thai, N. and P. Van Thom. Research on the Characteristics of Tooth Shape and Size of the Oval Gear Drive with an Involute Profile. in Regional Conference in Mechanical Manufacturing Engineering. 2021. Springer.
[3] Bair, B.-W., et al., Tooth profile generation and analysis of oval gears with circular-arc teeth. Mechanism and machine theory, 2009. 44(6): p. 1306-1317.
[4] Huang, Z., S. Zhi, and C. Shi. Design and Experiment of a Teaching Tool for Oval Gears with Variable Transmission Ratio. in Journal of Physics: Conference Series. 2021. IOP Publishing.
[5] García Hernández, C., et al., WEDM manufacturing method for noncircular gears, using CAD/CAM software. 2016.
[6] Li, F., Z. Yin, and Z. Zhang, Transmission design of noncircular gear and special gear. 1983, China Machine Press, China.
[7] Guo, C., W. Fu, and Z. Peng, The Design and Optimization of Movement Combination for Oval Gear and Sine Mechanism. 2002.
Modares Mechanical Engineering
Volume 23, Issue 10
October 2023
Pages 245-248