Modares Mechanical Engineering

Modares Mechanical Engineering

Constraint-controlled optimization and exergy assessment of a simple R1233zd(E) ORC for high-temperature exhaust heat recovery

Document Type : Original Article

Authors
Department of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran
10.48311/mme.2026.122197.83061
Abstract
High-temperature exhaust streams contain substantial recoverable energy, but simple organic Rankine cycle (ORC) performance is often governed by interacting thermal and fluid-property constraints. This study develops a physically constrained optimization, exergy assessment, and sensitivity framework for a simple subcritical ORC using low-global-warming-potential R1233zd(E). A fixed-composition natural-gas-turbine exhaust enters at 543 °C and 80.4 kg s⁻¹, with temperature-dependent properties evaluated using NASA7 ideal-gas correlations. The counter-flow heat-recovery vapor generator includes a 15 K pinch constraint, a 120 °C minimum stack temperature, and cooling-water approach limits. Decision variables are evaporation-pressure ratio, condensation temperature, and superheating degree; working-fluid properties are calculated with CoolProp 7.2.0. An independent numerical rerun reproduces the same constraint-controlled boundary design within numerical tolerance. The retained design delivers 6119.49 kW net power and 16.388% thermal efficiency at an evaporation-pressure ratio of 0.849996, condensation temperature of 38.000 °C, and 4.580 K superheating. The stack-temperature, condenser-approach, and critical-temperature safety constraints are active, while the actual minimum HRVG temperature difference is 80.18 K, confirming that the pinch constraint is inactive. The hot-gas physical-exergy decrease is about 18.22 MW, with a net physical-exergy recovery ratio of 33.58%. Exergy analysis identifies the HRVG as the main source of irreversibility. Overall, the results show that source–working-fluid temperature mismatch limits the suitability of a simple subcritical R1233zd(E) cycle for high-temperature exhaust recovery.
Keywords
Subjects

 

[1] S. Quoilin, M. Van Den Broek, S. Declaye, P. Dewallef, and V. Lemort, "Techno-economic survey of Organic Rankine Cycle (ORC) systems," Renewable and Sustainable Energy Reviews, vol. 22, pp. 168–186, 2013. doi: 10.1016/j.rser.2013.01.028.
[2] B. F. Tchanche, G. Lambrinos, A. Frangoudakis, and G. Papadakis, "Low-grade heat conversion into power using organic Rankine cycles: A review of various applications," Renewable and Sustainable Energy Reviews, vol. 15, no. 8, pp. 3963–3979, 2011. doi: 10.1016/j.rser.2011.07.024.
[3] J. Bao and L. Zhao, "A review of working fluid and expander selections for organic Rankine cycle," Renewable and Sustainable Energy Reviews, vol. 24, pp. 325–342, 2013. doi: 10.1016/j.rser.2013.03.040.
[4] E. Macchi and M. Astolfi, Eds., Organic Rankine Cycle (ORC) Power Systems: Technologies and Applications. Woodhead Publishing, 2016.
[5] A. Toffolo, A. Lazzaretto, G. Manente, and M. Paci, "A multi-criteria approach for the optimal selection of working fluid and design parameters in Organic Rankine Cycle systems," Applied Energy, vol. 121, pp. 219–232, 2014. doi: 10.1016/j.apenergy.2014.01.089.
[6] J. C. Jiménez-García, A. Ruiz, A. Pacheco-Reyes, and W. Rivera, "A Comprehensive Review of Organic Rankine Cycles," Processes, vol. 11, no. 7, 1982, 2023. doi: 10.3390/pr11071982.
[7] P. Colonna, E. Casati, C. Trapp, T. Mathijssen, J. Larjola, T. Turunen-Saaresti, and A. Uusitalo, "Organic Rankine Cycle power systems: From the concept to current technology, applications, and an outlook to the future," Journal of Engineering for Gas Turbines and Power, vol. 137, no. 10, 100801, 2015. doi: 10.1115/1.4029884.
[8] M. Lecompte, H. Huisseune, M. van den Broek, B. Vanslambrouck, and M. De Paepe, "Review of organic Rankine cycle (ORC) architectures for waste heat recovery," Renewable and Sustainable Energy Reviews, vol. 47, pp. 448–461, 2015. doi: 10.1016/j.rser.2015.03.089.
[9] S. Eyerer, C. Wieland, A. Vandersickel, and H. Spliethoff, "Experimental study of an ORC (Organic Rankine Cycle) and analysis of R1233zd-E as a drop-in replacement for R245fa for low temperature heat utilization," Energy, vol. 103, pp. 660–671, 2016. doi: 10.1016/j.energy.2016.03.034.
[10] J. Yang, Z. Sun, B. Yu, and J. Chen, "Experimental comparison and optimization guidance of R1233zd(E) as a drop-in replacement to R245fa for organic Rankine cycle application," Applied Thermal Engineering, vol. 141, pp. 10–19, 2018. doi: 10.1016/j.applthermaleng.2018.05.105.
[11] S. Eyerer, F. Dawo, J. Kaindl, C. Wieland, and H. Spliethoff, "Experimental investigation of modern ORC working fluids R1224yd(Z) and R1233zd(E) as replacements for R245fa," Applied Energy, vol. 240, pp. 946–963, 2019. doi: 10.1016/j.apenergy.2019.02.086.
[12] F. Dawo, J. Fleischmann, F. Kaufmann, C. Schifflechner, S. Eyerer, C. Wieland, and H. Spliethoff, "R1224yd(Z), R1233zd(E) and R1336mzz(Z) as replacements for R245fa: Experimental performance, interaction with lubricants and environmental impact," Applied Energy, vol. 288, 116661, 2021. doi: 10.1016/j.apenergy.2021.116661.
[13] M.-H. Yang, M.-C. Liu, and R.-H. Yeh, "Investigation of low-GWP working fluids as substitutes for R245fa in organic Rankine cycle application," Heliyon, vol. 10, no. 14, e34219, 2024. doi: 10.1016/j.heliyon.2024.e34219.
[14] M. Lampe, M. Stavrou, H. M. Bücker, J. Gross, and A. Bardow, "Simultaneous optimization of working fluid and process for Organic Rankine Cycles using PC-SAFT," Industrial & Engineering Chemistry Research, vol. 53, no. 21, pp. 8821–8830, 2014. doi: 10.1021/ie5006542.
[15] X. Zhang, X. Wang, P. Yuan, Z. Ling, X. Bian, J. Wang, H. Tian, and G. Shu, "Experimental study on the comparative performance of R1233zd(E) and R123 for organic Rankine cycle for engine waste heat recovery," International Journal of Green Energy, vol. 21, no. 14, pp. 3305–3312, 2024. doi: 10.1080/15435075.2024.2376734.
[16] X. Li, Y. Chen, Y. Zhang, and Y. Liu, "Thermoeconomic modelling and multi-objective optimisation of ORC systems for low-temperature waste heat recovery," Applied Thermal Engineering, vol. 279, Part B, 127603, 2025. doi: 10.1016/j.applthermaleng.2025.127603.
[17] J. Yang, Z. Ye, B. Yu, H. Ouyang, and J. Chen, "Simultaneous experimental comparison of low-GWP refrigerants as drop-in replacements to R245fa for organic Rankine cycle application: R1234ze(Z), R1233zd(E), and R1336mzz(E)," Energy, vol. 173, pp. 721–731, 2019. doi: 10.1016/j.energy.2019.02.054.
[18] M. Chaczykowski, "Organic Rankine Cycle for Residual Heat to Power Conversion in Natural Gas Compressor Station. Part II: Plant Simulation and Optimisation Study," Archives of Mining Sciences, vol. 61, no. 2, pp. 259–274, 2016. doi: 10.1515/amsc-2016-0019.
[19] B. J. McBride, M. J. Zehe, and S. Gordon, NASA Glenn Coefficients for Calculating Thermodynamic Properties of Individual Species, NASA/TP-2002-211556, NASA Glenn Research Center, Cleveland, OH, USA, 2002.
[20] I. H. Bell, J. Wronski, S. Quoilin, and V. Lemort, "Pure and pseudo-pure fluid thermophysical property evaluation and the open-source thermophysical property library CoolProp," Industrial & Engineering Chemistry Research, vol. 53, no. 6, pp. 2498–2508, 2014. doi: 10.1021/ie4033999.
[21] R. Storn and K. Price, "Differential Evolution - A Simple and Efficient Heuristic for Global Optimization over Continuous Spaces," Journal of Global Optimization, vol. 11, no. 4, pp. 341–359, 1997. doi: 10.1023/A:1008202821328.
[22] M. D. Morris, "Factorial Sampling Plans for Preliminary Computational Experiments," Technometrics, vol. 33, no. 2, pp. 161–174, 1991. doi: 10.1080/00401706.1991.10484804.
[23] European Commission, "Waste Heat Recovery for Power Valorisation with Organic Rankine Cycle Technology in Energy Intensive Industries (TASIO)," CORDIS, Project 637189, 2020, accessed Sep. 20, 2026.
[24] K. Braimakis and S. Karellas, "Thermodynamic investigation of integrated organic Rankine cycle-ejector vapor compression cooling cycle waste heat recovery configurations for cooling, heating and power production," Energy, vol. 304, 132020, 2024. doi: 10.1016/j.energy.2024.132020.
[25] L. Li, Y. T. Ge, and S. A. Tassou, "Experimental Study on a Small-scale R245fa Organic Rankine Cycle System for Low-grade Thermal Energy Recovery," Energy Procedia, vol. 105, pp. 1827–1832, 2017. doi: 10.1016/j.egypro.2017.03.531.
[26] T. Klamrassamee, T. Kittijungjit, Y. Sukjai, and Y. Laoonual, "Thermodynamic, economic, and carbon emission evaluation of various Organic Rankine cycle configurations for maximizing waste heat recovery potential," Energy Conversion and Management: X, vol. 26, 100943, 2025. doi: 10.1016/j.ecmx.2025.100943.
[27] T. Kittijungjit, T. Klamrassamee, Y. Laoonual, and Y. Sukjai, "Comprehensive study on waste heat recovery from gas turbine exhaust using combined steam Rankine and organic Rankine cycles," Energy Conversion and Management: X, vol. 25, 100825, 2025. doi: 10.1016/j.ecmx.2024.100825.
[28] K. Rahbar, S. Mahmoud, R. K. Al-Dadah, N. Moazami, and S. A. Mirhadizadeh, "Review of organic Rankine cycle for small-scale applications," Energy Conversion and Management, vol. 134, pp. 135–155, 2017. doi: 10.1016/j.enconman.2016.12.023.
[29] A. Mariani, B. Morrone, D. Laiso, M. V. Prati, and A. Unich, “Waste Heat Recovery in a Compression Ignition Engine for Marine Application Using a Rankine Cycle Operating with an Innovative Organic Working Fluid,” Energies, vol. 15, no. 21, 7912, 2022, doi: 10.3390/en15217912.