The spring-back of a work-piece during machining operation causes dimensional error of the work-piece. In the present study, the spring-back of work-piece in ultrasonic-vibration assisted turning and conventional turning has been modeled. It is illustrated that the reaction of the work-piece in high frequency vibration cutting is similar to a static behavior, whereas the spring-back in this process is theoretically and experimentally smaller than the conventional cutting leading to smaller error. A method has also been proposed to obtain the errors caused by rigid assumption of the spindle assembly used for correction of the results.
nategh,M J . (2011). Machining error due to spring-back of work-piece in conventional and ultrasonic vibration assisted turning. Modares Mechanical Engineering, 11(3), 27-42.
MLA
nategh,M J . "Machining error due to spring-back of work-piece in conventional and ultrasonic vibration assisted turning", Modares Mechanical Engineering, 11, 3, 2011, 27-42.
HARVARD
nategh M J. (2011). 'Machining error due to spring-back of work-piece in conventional and ultrasonic vibration assisted turning', Modares Mechanical Engineering, 11(3), pp. 27-42.
CHICAGO
M J nategh, "Machining error due to spring-back of work-piece in conventional and ultrasonic vibration assisted turning," Modares Mechanical Engineering, 11 3 (2011): 27-42,
VANCOUVER
nategh M J. Machining error due to spring-back of work-piece in conventional and ultrasonic vibration assisted turning. Modares Mechanical Engineering. 2011;11(3):27-42 (In Persian).
