Modares Mechanical Engineering

Volume & Issue: Volume 17, Issue 9, November 2017

Number of Articles: 45

Online proportional myoelectric control of a humanoid shoulder motions using electromyogram signals

Pages 1-12

Armin Ehrampoosh, Aghil Yousefi-Koma, Moosa Ayati, Seyed Saeid Mohtasebi

Numerical Analysis on the Effects of Impeller Geometry Parameters for a Centrifugal Pump in Reverse Operation

Pages 13-24

Dariush Mohammadipour, Amir Farhad Najafi, Hamed Alemi Arani, Alireza Riasi

Trajectory Investigation of a Transonic Spherical Projectile under Hop-Up Mechanism Using Simulation of Turbulent Three-Dimensional Non-Stationary Flow

Pages 25-35

Seyed Erfan Salimipour, Ali Reza Teymourtash, Mojtaba Mamourian

Thermoelastic buckling of functionally graded rectangular plate based on improved third order shear deformation theory

Pages 36-44

Hirbod Ahmadifar, Amin Yaghootian

Designing backstepping controller for positionforce tracking of cooperative robot manipulators

Pages 45-54

Shima Ahangar, Zahra Rahmani, Barmak Baigzadehnoi

Analysis of dimensional errors for metallic bipolar plates in single PEM fuel cell

Pages 55-64

Pouya Pashaie, Mohsen Shakeri, salman nourouzi

Numerical simulation of magnetic nanoparticle delivery at location of abdominal aortic bifurcation using single wire magnetic source

Pages 65-74

Saber Yekani Motlagh, Salar Deyhim

Numerical simulation of wind turbine in Manjil wind farm considering wind regime study

Pages 75-85

Mohammad Reza Ghasemi Bousejin, ali jafari, Seyed Saeid Mohtasebi, kobra gharali

Thermo-mechanical behavior of polymer composites exposed to fire

Pages 86-96

Khosro Lari, Mohammad Gholamian, Amid Pouraminaei, Emad Jomehzadeh

A Closed Loop Sub-Optimal Guidance Design for Sub-Orbital Flying Systems

Pages 97-106

Emad Jomehzadeh, farhad tavakoli

Design of Geosynchronous Satellite Flying Formation Based on Translational Dynamics Affected by Attitudinal Situation at Drift Phase

Pages 107-118

Amir Reza Kosari, Mahdieh Beglari

Agility enhancement using an assistive controller for exoskeleton robots

Pages 119-129

Iman Kardan, Alireza Akbarzadeh

Using of Turkel precondition method for convergence acceleration of compressible flow with low Mach number

Pages 130-136

mohsen motamedi, saeed sheikhi

Evaluation and optimization of drawing depth in electrohydraulic forming (with bridge wire between electrodes)

Pages 137-144

Mehdi Zohoor, Seyed Meysam Mousavi

A new method to reach high-density ratios and low viscosities based on the Shan-Chen multiphase model in lattice Boltzmann method

Pages 145-152

Soroush Fallah kharmiani, Mohammad Passandideh-Fard

A study of fluid media and size effect on dynamic response of microplate

Pages 153-164

Mahdi Aghababaie Beni, Mohamad-Reza Ghazavi, Ghader Rezazadeh

Study of the effect of elastic properties on non-Newtonian drop motion in inertia regime

Pages 165-174

Amin Emamian, Mahmood Norouzi, Mahdi Davoodi

Numerical Simulation of the Unsteady Wake Flow around a Marine Propeller Using URANS Model

Pages 175-184

Mohammad Reza Nazari, amin talezade shirazi, Mojtaba Dehghan Manshdi

The wall spring constant variation effect on distribution of Lennard-Jones fluid in nanochannel by molecular dynamic simulation

Pages 185-194

reza rabani, Ghassem Heidarinejad, ebrahim shirani

Parametric Analysis of a Nanofluid Based Photovoltaic Thermal System, Using Computational Fluid Dynamic

Pages 195-204

Mohammad Hosseinzadeh, Ali salari, Mohammad Sardarabadi, Mohammad Passandideh-Fard

Comparison of effects of adding various carbon nanotube concentrations and increase C/H mass ratio of liquid fuels on combustion behavior and flame thermal radiation

Pages 205-213

Mehdi Boghrati, Mohammad Moghiman, Seyed Hadi Pourhoseini

Numerical investigation of dynamic crack growth in steel pipes under internal detonation loading

Pages 214-224

hosein niasari, Gholamhossein Liaghat

Occurrence of parametric resonance in vibrations of rectangular plates resting on elastic foundation under passage of continuous series of moving masses

Pages 225-236

Ehsan Torkan, Mostafa Pirmoradian, Mohamad Hashemian

Accuracy Evaluation of Semi-empirical and Numerical Methods in Estimation of Aerodynamic Coefficients for air-launch-to-orbit delta wing

Pages 237-244

mohammad aelaei, Fathollah Ommi, Saeed Karimian aliabadi

An experimental investigation on viscous fingering instability of Newtonian fluid in transparent porous media with compact structure consist of glass beads

Pages 245-253

Seyed Majid khatibi, Ali Khaleghi, Mahmood Norouzi

Study on the effect of gap pressure on the geometric characteristics of the tungsten carbide powder produced by electrical discharge

Pages 254-260

Mohammad Reza Shabgard, Reza Najati Ilkhchi, Farid Kabirinia

Micromechanical modeling of effective elastic properties of hybrid nanocomposites reinforced by fuzzy fiber containing carbon nanotubes

Pages 261-272

Mohammad Kazem Hassanzadeh-Aghdam, MohammadJavad Mahmoodi, Hooshang Barkhordari

EXPERIMENTAL INVESTIGATIONS ON HEAT TRANSFER IN DOWNWARD COCURRENT TWO PHASE FLOW IN VERTICAL PIPES.

Pages 273-280

hamid hemmati, mansoor shirvani, omid vahidi, salman movahedirad

Experimental investigation of ground effects on aerodynamics characteristics of a delta wing airplane model

Pages 281-289

seyyed arash seyyed shams taleghani, Arsalan Ghajar, Mohammad Reza Soltani, Mehran Masdari

Numerical simulation of the characteristic chart and the steady state wake flow past a marine propeller using OpenFOAM

Pages 290-300

Mohammad Reza Nazari, Amin Talezade Shirazi, Mojtaba Dehghanmanshadi

Dynamical parameters identification of shear structure using block pulse functions and ARX model

Pages 301-308

Vortex Induced Vibration of Simply Supported Visco elastic Beam

Pages 309-318

Gholam Reza Zarepour, ilghar javanshir

Micromechanical analysis of the effects of adding silica nanoparticles on the elastoplastic behavior of polymeric nanocomposites considering interphase

Pages 319-326

Mahdi Hasanzadeh, Reza Ansari, mohammad kazem Hassanzadeh-Aghdam

Experimental Investigation of aero acoustic noise generation process from a wall mounted square cylinder at incidence

Pages 327-338

Alireza Movahedi, Ali Akbar Dehghan, Mojtaba Dehghan manshadi

Fabrication and Thermal Modeling of Unglazed Transpired Solar Air Heater Collectors with metallic (Steel) and non-metallic absorber plates

Pages 339-350

Fatemeh Afzali, Hossein Amiri, Vahid Nakhaei, Mehran Ameri

Design of decision-making lane change algorithm of truck-semitrailer in real dynamic environment

Pages 351-360

saeed shojaei, Ali Rahmani Hanzaki, Shahram Azadi, Mohammad Amin saeedi

Experimental Determination and Numerical Prediction of Necking and Fracture Forming Limit Curves of 2024 Aluminum Alloy Sheet Using Damage Criterion

Pages 361-371

Ali Zahedi, Bijan Mollaei-Dariani, Mohammadjavad Mirnia

Analysis of Laser Interfrometry Parameters in the Evaluation of Defects in the Polymer Matrix Composites

Pages 372-380

Davood Akbari, Hamidreza Asemani, naser soltani

Improvement of wearing property of Al/ (SiC+BNh) surface hybrid composite fabricated by friction stir processing

Pages 381-389

Masoud Mosallaee‌, ameneh daneshgar

Effect of accumulative roll bonding process on microstructure and hardness of A356/TiC cast composite

Pages 390-396

Pejman Momeni, Roohollah Jamaati

Investigation of the mechanical properties of the porous scaffolds used in bone tissue engineering by means of micromechanical modeling

Pages 397-408

Sayed Misagh Imani, Sayed Mahmood Rabiee, Ali Moazami Goudarzi, Morteza Dardel

A Weakly Coupled Scheme for Modelling Bedload Sediment Transport Using an Augmented Riemann Solver

Pages 409-416

Mina Barzgaran, Hossein Mahdizadeh, Salman Pouresmaeil

A numerical analysis of an active micromixer with the oscillating stirrer at the different aspect ratios by LBM

Pages 417-426

Hojjat Khozeymeh-Nezhad, Hamid Niazmand

Dynamic analysis of long thick cylindrical shell subjected to dynamic internal pressure using high order shear deformation theory

Pages 427-438

Sayyed Ali Azarpazhoo, Sayyed Roohollah Kazemi

Effects of suction/injection on flow and heat transfer over a permeable surface in presence of different nanofluids

Pages 439-449

Hamid Maleki, Mohammad Zolfaghar, Mahdi Mohseni

Journal Archive

Volume 26 (2026)

Volume 25 (2025)

Volume 24 (2024)

Volume 23 (2023)

Volume 22 (2022)

Volume 21 (2021)

Volume 20 (2020)

Volume 19 (2019)

Volume 18 (2018)

Volume 17 (2017)

Volume 16 (2016)

Volume 15 (2015)

Volume 14 (2014)

Volume 13 (2013)

Volume 12 (2012)

Volume 11 (2011)

Volume 10 (2010)

Volume 9 (2009)

Volume 8 (2008)

Volume 7 (2007)

Volume 6 (2006)

Volume 1 (2001)